Back to top

Run connections

Last updated December 6th, 2023

Synchronization occurs automatically according to the schedule specified. The Sync Interval value can be set while adding a connection (see Connect to AD/LDAP). You can also perform on-demand synchronization at any time and can also add additional targets while doing so. The pop-up page that appears when running an on-demand connection shows the expected number of targets, which helps you determine whether or not to run the synchronization.

Run a connection automatically

Synchronize data automatically on the schedule specified. When adding or modifying connections, select Use next to Scheduler and specify schedules for automatic synchronization. For more details, see Connect to AD/LDAP.

The history of the connection can be viewed in Setting > Identity & Directory > History.

Run a connection on demand

Synchronize data on demand at any point in time by choose to synchronize the targets already specified for a service or adding, modifying, or deleting targets as needed.

To run a connection on demand, complete the following steps:

  1. Navigate to Setting > Identity & Directory > Connection.

  2. On the Connection page, click the check box for a connection and click Sync.

  3. In the Sync page, select a sync target type, select to preview the sync result before starting sync, and click OK.

  4. In the Expected Sync Results page, check the expected synced targets and click OK.

    Note

    Navigate to Setting > Identity & Directory > History to view the history of the connection.

Is this page helpful?