VMware Workspace ONE UEM: Deploy dedicated device

To enroll a device in the Android Enterprise dedicated device deployment type, the final pre requisites are you need to ensure that the legacy Android container options are disabled and that the Android EMM Registration Enrollment Settings are set correctly. Follow these steps:

1. Go to Groups & Settings > All Settings > Devices & Users > Android > Intelligent Hub Settings

2. About half way down you will see a Samsung KNOX section. Set Enable Containers to DISABLED and ensure the Knox License Key field is blank. Then scroll all the way to the bottom and click Save.

   

To ensure that the Android EMM Registration Enrollment Settings are set correctly.

1. Go to Groups & Settings > All Settings > Devices & Users > Android > Android EMM Registration > Enrollment Settings

2. Ensure Work Managed Enrollment Type is set to DEVICE-BASED and Fully-Managed Device Enrollments is set to WORK MANAGED DEVICE.

   

The Android Enterprise dedicated device deployment type has been integrated into the VMware Launcher profile. So you need to ensure that your Launcher profile has been created and assigned to your device prior to enrolling. You can create this profile by going to:

• Devices > Profiles & Resources > Profiles > ADD > Android > Launcher

Once you have done this you than then enroll your device. To enroll your device, you need to ensure the device is factory reset and at the welcome screen. From here, there are 3 ways you can enroll your device into Workspace ONE UEM as an Android Enterprise dedicated device.

• DPC Identifier [Also known as the hashtag method] afw#hub
• QR Code Enrollment / NFC Enrollment
• Knox Mobile Enrollment

Below is a screen-by-screen play to enroll your device using the DPC Identifier method.